General Instructions; Understanding Your Safety Seat - JANE Koos iSize Mode D'emploi

D. GENERAL INSTRUCTIONS
In order to protect your baby adequately and to ensure their comfort
and stability in the car, the following instructions must be strictly followed:
This seat is only suitable for cars fitted with the ISOFIX anchoring system,
approved under Regulation ECE-14 or other equivalent standards.
Your KOOS iSIZE safety seat can be installed in both the front seat, if it
does not have an airbag, and in the back seat of your car. Either way,
we advise you to install it in the back seat. If you position it in the front
seat of the car, this must NOT have an AIRBAG, or the airbag must be
disconnected.
WARNING: Check the road traffic regulations in the country where you
are travelling. The use of your child restraint system may be restricted.
Not all safety systems are exactly the same, so we advise that you
check your KOOS iSIZE in the car in which it is going to be fitted.
It is very important not to use second-hand products, as JANÉ can only
guarantee complete safety with items used by their first buyer.
JANÉ recommends that you replace your KOOS iSIZE safety seat with
a new one if it has been subjected to violent stresses in an accident.
Check that all the seat straps are in the correct position and duly
adjusted in your KOOS iSIZE. Make sure that none of the straps are
twisted. Make sure the child understands he must never play with
the straps or fasteners.
E. UNDERSTANDING YOUR SAFETY SEAT
Your KOOS iSIZE safety seat has been designed with the latest safety
developments in mind and has been tested under the toughest
conditions. It has the following features:
Installation in cars:
Ready for quick installation on a base with the ISOFIX system
(See the section titled INSTALLING THE SAFETY SEAT IN YOUR
VEHICLE with the base and also without the base, with the vehi-
cle seat belts (see relevant section G. KOOS iSIZE INSTALLATION
WITH THE VEHICLE SEAT BELT).
Comfort and safety for your baby:
Integrated 3-point harness.
Ventilation in the chassis making it breathable.
Impact-absorbent material on the entire surface that comes into
contact with the baby.
Headrest to protect the child's head, adjustable to 5 different heights.
Comfort for the parents:
Pro-fix anchors compatible with any Jané pushchair (always consult
the instructions for each chassis to check compatibility before fitting
the seat)
Carry handle, with 3 positions:
Position 1: Resting. In this position the handle lies flat against the frame.
EN 45