JANE Koos iSize Mode D'emploi page 47

Adjust the height of the leg (1) so that it rests on the floor of the
vehicle, the indicator on the base of the leg (10) and the indicator on the
leg adjustment button (5b) will turn green.
WARNING: You will also find a specific list of instructions on the
!
platform.
INSTALLING THE KOOS iSIZE ON THE iPLATFORM
Position the baby carrier so that it is fastened with the Pro-Fix anchors
2
intended for the KOOS iSIZE (8). .a
Check that both sides are securely anchored, your KOOS iSIZE will click
when it is correctly locked in place and a green strip will be displayed
on the Pro-Fix lever (found on the handle dial).
Set the KOOS iSIZE handle to the CAR position, make sure that it is
locked in place, and that the whole car symbol is displayed.
do this, simultaneously press the release buttons found on both
sides of the handle, and set it to the position that is furthest
forward. 2 .d
Turn the handle (5) so the whole group is firmly pressed against the
vehicle backrest.
1 .d
!
Set the KOOS iSIZE handle to the Carrying position.
Pull the release levers on both sides of the handle to release the
Pro-fix anchors and lift the baby carrier up.
To remove the platform:
2 .b
Release the ISOfix anchors by pressing the buttons (4), the signal on
the buttons will turn red.
2
.c To
Loosen the platform by turning the handle on the side (5).
The ISOfix anchors can be hidden away inside the platform by turning
the handle on the side (5).
2 .e
WARNING: Your iPLATFORM can be used with two different baby ca-
rrier models, make sure you insert the Pro-fix of your KOOS iSIZE into
the correct position for this model, you will find the instructions on
the platform. Once anchored, the exterior surface of the safety seat
backrest should be touching the fastening bar (9)
DETACHING THE KOOS iSIZE FROM THE iPLATFORM
2 .h
2 .i
2
.f
2 .g
2 .i
EN 47