Publicité
Les langues disponibles
Les langues disponibles
Volkswagen Polo
1999 - ....
Ref. 1199
Fitting instructions
1)
Remove the bumper in the rear and detach the exhaust from the rubbers.
2)
Slide the tow bar with the supporting arms in the chassis so that the points (A) fit the drill holes provided
in the bottom of the chassis, which are sealed off with rubbers (these must be removed). Insert the bolts
and washers through the bottom, but do not tighten yet.
3)
Points (B) come against the rear of the bodywork, these points must be drilled through with
till in the trunk. Insert the bolts and washers through the trunk and tighten everything firmly.
4)
Before reinstalling the bumper, make an incision in the middle of the bumper. This incision is 60mm wide
and 55 mm measured from the bottom edge of the bumper.
5)
Assemble the (*) and tighten firmly.
Composition
1 tow bar reference 1199
1 ball T44M000
2 bolts M10-35 + moeren
4 bolts M10-35
2 bolts M12-70
4 washers 40-12-4
2 washers 65-25
2 safety nuts M12
6 safety washers 10 mm
1 security shackle (800053)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(B)
(A)
(*)
(A)
(B)
(*)
(A-B)
(*)
All bolts and nuts: quality 8.8
10,5mm
Publicité
