Briteq BTX-TITAN SIRIUS HRI 280 Mode D'emploi page 11

ENGLISH
LAMP CONTROL
Set the lamp ON or OFF
CHANNEL MODE
Set the channel mode of BriteQ BTX-TITAN:
 Mode 1: 24 Channels
 Mode 2: 25 Channels
 Mode 3: 17 Channels
DMX INPUT
is green:
is red and lcd is blinking:
Used to set the desired input for the DMX signal:
 Wired Input: XLR (3 or 5pin) input is used.
 Wireless Input: DMX-signal comes from an external wireless transmitter (sold separately)
 Wireless Input / XLR out: DMX-signal comes from an external wireless transmitter (sold separately). The
wireless DMX-signal is also available at the DMX output port (3 or 5 pins) for further daisy chaining of
other equipment.
Important Remark: originally this projector is NOT equipped with a wireless receiver module. A wireless
receiver module is optionally available.
DMX ADDRESS
Set the DMX address by pressing the center of the screen at least 2 seconds (yellow progress bar appears
on the screen) and DMX Address panel appears. DMX address can be modified with the slider on the touch
screen or with the "+" and "-" button. The ">>" icon sets the last valid DMX address, according to the selected
channel mode. The "<<" sets the address to 1. Confirm the DMX address by pressing ENTER. The main
page is now updated, and the DMX range used by the product is on the right down corner of the screen.
CHANNEL LIST
Pressing on the DMX address range xxx-xxx on the main screen shows the DMX-chart according to the
selected channel mode.
ERROR MESSAGES
Press the -ICON: a list of error messages will apprear. Please check the list of error codes at the end of
the user manual.
SETTINGS MENU
Press "Settings" on the display to open the setup menu. Use the UP/DOWN, MODE and ENTER-buttons to
navigate.
BRITEQ
®
received DMX-signal is OK.
received DMX-signal is NOT OK or NO DMX-signal received.
9/107
OPERATION MANUAL
BTX-TITAN