Briteq BTX-TITAN SIRIUS HRI 280 Mode D'emploi page 10

ENGLISH
OPERATING INSTRUCTIONS
 Do not switch the unit on and off in short time intervals as this reduces the lamp life.
 Always unplug the unit when it is not used for a longer time or before replacing the bulb and or making the
service.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
MENU
You can use the buttons or touch screen to navigate the setup menu with its different sub menus etc. You
can easily change settings like DMX address, different functions etc.
 Use the UP / DOWN buttons to navigate the menu and change the values of the selected functions.
 Each time you select a menu item or change a setting you must press the ENTER button to confirm.
 Press the MENU button to return to the (previous) menu.
TOUCHSCREEN – MAIN INTERFACE LAYOUT:
When the unit is switched on, the display shows the BriteQ logo, followed by the main interface as shown
below. The main interface is splitup in different parts (icons). You can press these icons, which are in fact
shortcuts, to immediately access different parts of the setup menu (see drawing).
FIXTURE ID
The Fixture id (ranging from 0001 to 9999) makes installation easier because each product can be identified
by a unique number. With the internal battery, no need to plug the power to set or read the fixture id.
To change the fixture id a password is needed: the password is "1702".
BRITEQ
®
8/107
OPERATION MANUAL
BTX-TITAN