FLOWFITNESS TURNER DHT50UP Manuel page 41

Step 3
1. Connect the upper adjustment cable (17) with the lower adjustment cable (14)
as displayed in figure A-1. Pull the red plastic rotatable tube of the upper cable
back and downwards. The end of the red tube should be placed as displayed
within figure A-4.
By rotating the read tube the minimum resistance can increased or decreased.
Rotate clockwise to decrease the resistance and rotate counter clockwise to
increase the resistance.
2. Check if the cables are connected correctly by rotating the resistance knob.
The end of the upper cable (17) should increase or decrease tension in the
lower cable (14).
Connect the upper (24) and lower (25) computer cable.
3. Assemble the handlebar post (16) to the main frame (50) by fastening curved
washers (8), spring washers (29) and Allen bolts (15).
Important: for a correct assembly first place the spring washer (29) onto the
Allen bolt (15). Then place the curved washer (8) onto the Allen bolt. Screw the
Allen bolt with washers into the main frame.
B
INCREASE
DECREASE
A-1
A-2
14
A-3
A-4
16
17
17
24
25
C
Step-3
B
INCREASE
DECREASE
A-1
17
B
A-2
14
A-3
A-4
16
B
17
(x4)
14
29
15
M8*1.25*75L
8
50
D15.4*D8.2*2T
D22*D8.5*1.5T
Manual Turner DHT50 UP Hometrainer - 41
4. Use
(x4)
M8*1.25*75L
D15.4*D8.2*2T
D22*D8.5*1.5T