Table des Matières
Publicité
Allgemeiner Teil / General Section / Partie générale
5. Service Setting for the Dealer
5.1 Service Menu
By pressing button "M" call up the dialog line "Service code" via "TV-
menu" –> "Settings" –> "Special functions" –> "Service".
Having entered the code number "8640" the dealer can change the
following settings following the menu guide:
- GEOMETRIE
- WHITE ADJUSTMENT
- AGC
- OSD horizontal
- OSD vertical
- Hotel
- Tube
- Initial Mode
- End
Alignment: page 2-3
5.2 OSD Position
By pressing button "M" call up the dialog line "OSD" via "TV-menu" –>
"Settings" –> "Special functions" –> "Service" –> "OK" –> Service
code "8640".
With the or button it is possible to shift the on screen display in the
horizontal or vertical direction and to store this position "with mem.".
5.3 Hotel Mode
5.3.1 Activating the Hotel Mode
By pressing button "M" call up the dialog line "Hotel" via via "TV-
menu" –> "Settings" –> "Special functions" –> "Service" –> "OK" –>
Service code "8640".
With activated "Hotel Mode":
- it is no longer possible to call up the "TV-menu" with button "M".
- the last volume setting is stored as the maximum level possible.
5.3.2 Deactivating the Hotel Mode
Depress and hold button " " on the remote control handset while
switching the TV set on with the mains switch. Under the "Service"
menu switch the Hotel mode off.
5.4 Deactivating the Protection Circuit
Depress and hold button " " on the remote control handset while
switching the TV set on with the mains switch. The protection circuit of
the TV set will not be evaluated on video processor IC34015-(50), the
power supply will not be switched off. The menu may be displayed
depending on the fault.
6. Setting the Analog Values
Maximum
value
Brightness
Colour contrast
Black/white contrast
Volume
Sharpness
The analog values are stored automatically:
- after about 8 seconds,
- on switching to Standby mode,
- on switching over from TV to AV mode,
On disconnection from the mains, the normal values are activated
(individual settings).
1 - 18
Optimum
TDA 884x
63
32
63
26
63
50
63
22
5
2
7. Audio / Video Connectors
AV socket configuration (dependent on the TV receiver)
Socket
Input
AV1 black
RGB
(Pin 7,11,15)
CCVS
(Pin 20)
Pin
1
=
2
=
3
=
4
=
5
=
6
=
7
=
8
=
9
=
10
=
11
=
12
=
13
=
14
=
15
=
16
=
17
=
18
=
19
=
20
=
21
=
20
21
19
M 1000 / M 1001
Input
Switching
-
12V switching voltage
(Pin 8)
1V fastblanking
(Pin 16)
CCVS
12V
(Pin 19)
(Pin 8)
Signal
Audio output right
Audio input right
Audio output left
Audio ground
Blue ground
Audio input left
RGB blue input
Chroma input/output with SVHS
Switching voltage
Green ground
MEGALOGIC data lead
RGB green input
Data
Red ground
Ground
RGB red input
Chroma output/input with SVHS
RGB switching voltage
(1V Fastblanking)
Video ground
RGB switching voltage ground
CCVS output
CCVS / Y input
Shielding/ground
2
1
LOEWE.-Service
Publicité
Table des Matières
