Worx WG324E Notice Originale page 13

Masquer les pouces Voir aussi pour WG324E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
s) Do not remove battery pack from its original
packaging until required for use.
t) Observe the plus (+) and minus (–) marks on the
battery and ensure correct use.
X
SAVE THESE INSTRUCTIONS
Z
Y
W
Instructions concerning the proper techniques for
limbing and cross-cutting
1. Limbing a tree
X
Limbing is removing the branches from a fallen tree.
Z
When limbing leave larger lower limbs to support the
Y
W
log off the ground. Remove the small limbs in one cut as
2
illustrated in Figure 1. Branches under tension should
be cut from the bottom up to avoid binding the pruning
saw.
Figure 1
2. Bucking a log
Bucking is cutting a log into lengths. It is important to
make sure your footing is firm and your weight is evenly
distributed on both feet. When possible, the log should
be raised and supported by the use of limbs, logs or
chocks. Follow the simple directions for easy cutting.
When the log is supported along its entire length as
illustrated in Figure 2, it is cut from the top (overbuck),
avoid contacting ground as this will greatly reduce the
chain sharpness.
Figure 2
When the log is supported on one end, as illustrated
in Figure 3, cut 1/3 the diameter from the underside
( underbuck) (1). Then make the finished cut by
1
overbucking (2) to meet the first cut.
1/3
1
1/3
Cordless Pruning Saw
3
1
1
3
2
1
1
1
2
1
2
2/3
2
2/3
1
2
1
When the log is supported on both ends, as illustrated
in Figure 4, cut 1/3 the diameter from the top (overbuck)
(1). Then make the finished cut by underbucking (2) the
1
lower 2/3 to meet the first cut.
1
1/3
1
1/3
1
1/3
When bucking on a slope always stand on the uphill
side of the log, as illustrated in Figure 5. When "cutting
through", to maintain complete control release the
cutting pressure near the end of the cut without relaxing
your grip on the pruning saw handles. Don't let the chain
contact the ground. After completing the cut, wait for
the saw chain to stop before you move the pruning saw.
Always stop the motor before moving from tree to tree.
2
1/3
2/3
2
1/3
2/3
Figure 3
2
1/3
2/3
2
2/3
2
2/3
2
2/3
Figure 4
Figure 5
13
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wg324e.1Wg324e.9

Table des Matières