Frequencies (Hz); Continuity And Resistances (Ω/ ) - Chauvin Arnoux C.A 5230 G Notice De Fonctionnement

4 - FREQUENCIES
Connect the leads to the multimeter and connect in parallel to the
circuit to be tested.
Place the selector switch on the Hz voltage frequency function.
Automatic range selection: read the measured value
NB: The bargraph is inactive on frequency measurement
If necessary, press the following buttons:
- MIN-MAX to read the min or max values
- to light the display
Hz 100 Hz
Resolution 0.01 Hz
Accuracy
± 10 counts
Permitted
overload
Operating
range
(1)
(1) The RANGE button for this function selects the triggering threshold:
- 10 mV for 100 Hz, 1 kHz and 10 kHz ranges
- 400 mV for 100 kHz and 400 kHz ranges
(2) NB : If the frequency applied is 99.99 kHz, the decimal point oscillates between
9.999 kHz and 99.99 kHz.
5 - CONTINUITY AND RESISTANCES
Never test a resistance on a live circuit
Connect the leads to the multimeter and to the terminals of the
circuit or the component to be tested.
Place the selector switch on the ohmmeter function
Ω/
Press the button to change from the continuity sound test
to the measurement of resistances and reverse.
Automatic range selection: read the measured value
Memorise the value, if necessary, by pressing the HOLD button.
If necessary, press the following buttons:
RANGE to select the range manually
MIN-MAX to read the min or max values
to light the display
16
1 kHz 10 kHz 100 kHz
0.1 Hz 1 Hz 10 Hz
± 0.1% rdg
± 4 counts± 8 counts ± 20 counts
500 V rms and 900 V peak
4 V to 600 V
400 kHz
(2)
100 Hz
Ω