Candy CHICS 5182XWD Manuel D'utilisation page 13

bottom of the freezer door that may stick to the
door. Do not lose.
middle hinge part
special flange self
tapping screws
8. Place the lower door on a smooth surface with
its panel upwards. Loose screw ② and part ①,
then Install them to the left side and tighten
securely.
① Stop block
② Self-tapping screw
9. Change screw hole covers on middle cover
plate from left to right (as shown in figure
below).
screw hole covers
10. Lay the refrigerator on soft foam packaging or
similar material. Remove both adjustable bottom
feet parts, and remove the front feet board and
the lower hinge part by unscrewing the special
flange self-tapping screws.
screw hole covers
①
②
③
④
①
Lower hinge part (right)
② Front feet fixed board
③ Adjustable bottom feet part
④
Self-tapping screws
11. Unscrew the bottom hinge axis and remove it
to the hole which is side by side and screw it.
Washer
Note: washer may stick to lower door
12. Replace the lower hinge part to the left side
and fixing it with the special flange self-tapping
screws. Replace the front feet fixed board to
another side and fixing it with the special flange
self-tapping screws. Install the adjustable bottom
feet parts.
Lower hinge part (left)
front feet fixed board
13. Transfer the lower door to the property
position, adjust the lower hinge part, make the
hinge axis into the lower hole of the lower door,
then tight the bolts.
14. Upturn the middle hinge part the direction
180 degree, transfer it and adjust its position,
make the middle hinge axis into the upper hole
of the lower door, tight the bolts.
11