Getting Started - Ribimex Ribiland PRASBTD30 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not missing or damaged.
- If you find anything part missing or damaged, do not operate the tool
until the part has been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
4.2- Content
The unit package contains:
- Power unit
- Tubes
- Manual
4.3- Assembly
The blower requires some assembly prior to first time use, including fitting the blower tubes.
Put the machine on a clean, flat, solid and stable surface.
Ensure the throttle cable (11) is not stuck between the blower base and the surface or between the
blower base and the engine.
4.3.1- Attach the flexible tube
Loosen and insert a hose clamp (23) to the extremity of the flexible tube (5)
Fig.2: Connect the flexible tube end (B) to the fan's outlet tube (A).
Fig.3: Tighten the hose clamp (23) with a screwdriver.
4.3.2- Attach the operating tube
Loosen and insert a hose clamp (23) to the extremity of the flexible tube (5)
Fig.4: Connect the operating tube end (D) into the extremity (C) of the flexible tube (5).
Fig.5: Tighten the hose clamp (23) with a screwdriver.
Ensure that the screw of the hose clamp is positioned away from the operator's hand or wrist to avoid
any discomfort or injury.
Fig.6: Lay the throttle cable (11) as straight as possible along the flexible tube (5) and attach it with
the linkage clips (E).
4.3.3- Attach the intermediate tube and the nozzles
Insert intermediate tube (3) into the operating tube (4) and rotate clockwise to lock them.
Insert the nozzle (1) or (2) into the intermediate tube (3) and rotate clockwise to lock them.
Fig.2 Fig.3 Fig.4