Ribimex Ribiland PRASBTD30 Manuel D'instructions Et D'utilisation page 29

4. Fig.11: Move the choke lever (21) to first position
The choke will close and the throttle lever will then be set in the starting position.
5. With one hand on the transport handle (13), securely hold the machine on the ground, with the
other hand pull the starter rope (14) slowly then vigorously.
Important: Always pull the starter rope slowly until you feel the initial resistance before you then pull
it quickly to start the engine. Do not allow the starter rope to whip back of its own accord.
6. When engine has ignited but stopped push the choke lever to the second position
the starter again to start the engine.
After engine starts, wait for 10 sec, then move choke lever to third position
7. Allow the engine to warm up pulling on the throttle lever slightly.
Attention! When you attempt to start the machine for the first time or if the tank is completely empty,
you may have to pull the starter rope several times. If the engine fails to start, repeat above steps.
4.6.2- Stopping the engine
Emergency stopping procedure:
When it is necessary to stop blower engine immediately, press button (10) see Fig.9.
Normal operation stopping procedure:
1. Release the throttle switch (8) to allow the engine to idle for a few minutes.
2. Set the ON/OFF switch to STOP or "0" position.
V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens or lawns.
- The tool is not intended for professional or industrial use (ex.: in public parks, sports grounds...).
- The blower is designed to blow leaves as well as lawn debris such as grass clippings and small twigs
(smaller than 5mm). It is not to be used for any other purpose outside of the described scope in this
manual.
- The device is only to be used on dry surfaces, do NOT operate on damp or wet working area.
- Do not use the machine for unsuitable purposes (for ex. For blowing fire, flammable or explosive
material, blowing of metal clippings, nails ...)
5.2- Working with the blower
WARNING
- Before proceeding to your job, read the section "Safety".
It is recommended to first practice by blowing over a small surface. This also
helps you get accustomed to your machine.
- Wear personal protective equipment: gloves; safety footwear, snug fitting
clothing, goggles or face protection, hearing and head protection devices.
Use vibration-proof gloves.
ATTENTION! National or local regulations may restrict the use of the
machine to certain hours or periods. Check with your local authority.
Note: careful daily inspection should be performed before use and after a drop
or shock to identify major defects. Do not use the machine until the defects have
been repaired.
.
and then pull
.