Maintenance And Storage - Ribimex Ribiland PRASBTD30 Manuel D'instructions Et D'utilisation

5.2- Operation
- Place the blower on your back and adjust the shoulder strap in a comfortable position and hold the
control handle at hip height
- Always work away from solid objects such as walls, fences, etc. or objects likely to be damaged such
as cars, windows, greenhouses...
- Whilst you work do not place the blower tube too close to the leaves.
The machine will be more effective if you keep it at a certain distance away from the leaves and blow
the leaves forwards.
- Tips for using your blower
. Always try and blow dry leaves, cuttings or general garden debris. Wet materials are more difficult
to blow.
. Avoid using the blower on areas where there are stones, or other hard objects. These objects can be
thrown out or projected at great speed likely to damage your plants or objects nearby..
VI. MAINTENANCE AND STORAGE
WARNING - Before cleaning, the inspecting or repairing the unit, make sure that engine has
stopped and has cooled down.
Disconnect the spark plug to prevent accidental starting.
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage.
Any breach or default of adequate maintenance reduces the life of the machine and increases the risk
of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
6.1- Air filter
Loosen the knob and remove the air filter cover.
Take off the filter elements and tap them against a hard surface to remove dust and debris.
To clean dirt in the mesh or when the elements are extremely dirty, shake wash with gasoline.
Dry them completely before reinstalling.
Note: Replace air filter if frayed, torn, damaged or unable to be cleaned
6.2- Fuel filter
Remove the fuel tank cap (18).
Using a wire hook, take out the filter from the filler port.
Disassemble the filter and wash with gasoline, or replace with new one if clogged with dirt
completely (or if needed).
Notes: When returning the filter, use a long nose plier to avoid folding the suction pipe.
When assembling the filter, take care not to allow filter fibers or dust inside the suction pipe.
6.3- Adjusting the carburetor
The carburetor on your unit has been factory adjusted, and should not require any intervention.
However, should any adjustment be required, contact your local reseller.
Restrict working hours to a minimum and always take rest periods.
For proper use, after each work period take a rest period (for ex take a rest for
10 minutes after a work period of 30 minutes).