Getting Started - Ribimex Ribiland PRASB3000 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not missing or damaged.
- If you find anything part missing or damaged, do not operate the tool
until the part has been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
4.2- Content
The unit package contains:
- Power unit
- Vacuum/blower tubes
- 3 screws for tubes assembly
- 1 Collection bag
- 1 Shoulder strap
- Instructions manual
4.3- Assembly
The blower/vacuum requires some assembly prior to first time use.
This includes fitting the blow/vacuum tubes to the housing, shoulder strap and collection bag.
Warning! The Vacuum-Blower must NOT be used or switched on until it has been fully assembled.
WARNING: IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG IN THE MACHINE
UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED PART.
4.3.1- Tubes (Fig.2)
Remove the two tubes and screws from package.
Fig.2+3a: Insert tube (a) into tube (b) and fasten with of the long screws (c).
Fig.2+3b: Push tube section (b) into motor housing (3) and then tighten with the other long screw (s) and
the short screw (d).
Check that tubes assembly is correctly done and tightly secured.
Fig.2
4.3.2- Shoulder strap (Fig.4)
Open the snap fastener (a), and pass it the hanging point (6) next to the
handle and then close the snap fastener.
To adjust the shoulder strap to the required or desired length, simply slide
the adjustable strap buckle forward or backwards.
Fig.3a
Fig.3b
Fig.4
Page 25 / 45