Joie tilt Mode D'emploi page 7

9
1
10
3. Press the red button to
disengage the buckle -
9
and then place the infant body
support in the child restraint.
4. Engage the buckle until it clicks.
10
5. Pull the adjustment webbing
tight.
11
11
11
1,
9
Rearward Reclining Angle Adjustment
see images
12
While pushing the reclining
adjustment handle - 1, pull
12
the child restraint from the most
upright position to the most
reclined position. - 2
12
Angle indication: The top blue
diamond and bottom blue
diamond are aligned
(Position 4).
4
Note
1. Make sure the shoulder harness is adjusted to proper height
before installing this child restraint. Please refer to
of the Shoulder Harness Straps
Height Adjustment.
2. First adjust the angle of the child restraint to position 4. Angle
indication: Align the top blue diamond and bottom blue
diamond.
4
3. When installing and adjusting the vehicle belts, make sure that
both the shoulder belt and the waist belt are not twisted and
will not prevent the vehicle belts from functioning properly.
12
Proper Position
& Shoulder Harness Straps
12