Sun SWB 200S Notice D'utilisation page 82

82
5-49
5-50
5-51
5-52
Operation
Reading of error code E9
If E9 is read out, at least one error was made with respect
to the sequence of operations when performing optimisation
( 7.1 System messages).
F
Abort the optimisation program by pressing the STOP
—
key and, if desired, start optimisation once again.
Fig. 5-49 OPTIMISATION "OP.12"
(4th measuring run of tyre/rim assembly)
Clamp the wheel on the balancer.
—
Rotate the wheel such that the valve is exactly
—
perpendicular to and above the main shaft.
Confi rm the valve position by pressing menu key F1.
—
The OPTIMISATION "OP.13" screen (Fig. 5-50) is displayed.
Fig. 5-50 OPTIMISATION "OP.13"
START is displayed on the screen.
Press the START key.
—
A measuring run is performed.
BALANCING screen
The
Finish weight minimisation / optimisation
BALANCING
Fig. 5-51
If the wheel running conditions are optimal, the following
codes can be displayed (Fig. 5-52):
H0 Wheel running conditions cannot be improved by
optimisation.
H1 Further optimisation not recommended but feasible.
H2 Weight minimisation is recommended, optimisation can
achieve no further improvement.
(Fig. 5-51) is displayed.