Sun SWB 200S Notice D'utilisation page 58

58
5-21
5-22
5-23
Operation
5.8.1 Alu 2P and Alu 3P (HWM) weight
modes:
Refer to Figure 5.21.
The gauge arm must be used to apply the stick-on
weight(s).
Index the wheel to the exact position for correction
—
in the right correction plane.
When the position is reached, two green arrows
appear.
Press the pedal of the main shaft lock to hold the
—
wheel in this position.
Decide to use Hidden Weight Mode «HWM» now (
5.9).
Clean the fi tting position before attaching the
—
adhesive weights.
Insert at the centre of the gauge arm an
—
adhesive weight that complies with the imbalance
measured and remove the protective tape from
the adhesive strip (Figure 5-23).
Note: When the value "0" appears while moving the
arm, the machine beeps to indicate that the
correct application position has been reached.
• Apply the weight to the correct point on the rim.
• Rotate the wheel to the next WAP position, put the
stick-on weight on the gauge arm and apply the
weight at the left plane reference point (Fig. 5-21).
— After applying the balance weights perform a Test Run.
F