Cleaning The Outside Of Grills That Are In Unique Environments - Weber Spirit SP-335 Manuel Du Propriétaire

Cleaning the Cookbox
Look inside the cookbox for any grease accumulation
or leftover food particles. Excessive accumulation can
cause a fire.
1) Use a plastic scraper to scrape debris off the sides
and bottom of the grill into the opening in bottom of
the cookbox (G). This opening leads debris into the
slide-out catch pan.
Cleaning the Grease Management System
The grease management system consists of an angled
slide-out grease tray and a catch pan (H). These
components were designed to be easily removed,
cleaned, and replaced; an essential step every time
you prepare to grill. Instructions on inspecting the
grease management system can be found in MEAL-TO-
MEAL MAINTENANCE.
Cleaning the Outside of the Grill
The outside of your grill may include stainless steel,
porcelain-enameled, and plastic surfaces. WEBER
recommends the following methods based on the
surface type.
Cleaning Stainless Steel Surfaces
Clean stainless steel using a non-toxic, non-abrasive
stainless steel cleaner or polish designed for use on
outdoor products and grills. Use a microfiber cloth to
clean in the direction of the grain of the stainless steel.
Do not use paper towels.
Note: Do not risk scratching your stainless steel with
abrasive pastes. Pastes do not clean or polish. They
will change the color of the metal by removing the top
chromium oxide film coating.
Cleaning Painted, Porcelain-Enameled
Surfaces and Plastic Components
Clean painted, porcelain-enameled and plastic
components with warm soapy water, and paper towels
or cloth. After wiping down the surfaces, rinse and dry
thoroughly.
Cleaning the Outside of Grills that are in
Unique Environments
If your grill is subject to a particularly harsh
environment, you will want to clean the outside more
often. Acid rain, pool chemicals, and salt water can
cause surface rusting to appear. Wipe down the
outside of your grill with warm soapy water. Follow
up with a rinse and thorough drying. Additionally, you
may want to apply a stainless steel cleaner weekly to
prevent surface rust.
G
H
Cleaning the Side Burner Tube
Remove Side Burner Valve
You will need: A Phillips screwdriver.
1) Remove the two screws that secure the side
burner valve plate to the side burner table (I).
2) Release the side burner valve from burner
tube by gently pulling the assembly forward.
Exercise care not to kink the corrugated gas
line.
Clean the Burner Tube
You will need: A torch, a wire (a straightened-out
coat hanger), a suitable stainless steel bristle
brush.
1) Look inside the burner tube with a torch (J).
2) Clean any debris or blockage from the inside
of the tube with the wire.
Reinstall Side Burner Valve
You will need: A Phillips screwdriver.
1) Align side burner valve with side burner tube
opening.
2) Position the side burner tube properly over
the side burner valve orifice (K).
3) Secure the side burner valve plate to the side
burner table using two screws.
1
I
J
2
K
3
CAUTION: The side burner tube opening must
m
be positioned properly over the side burner
valve orifice.
4
5
6
7
17