Skil 7302 Consignes De Fonctionnement/Sécurité page 10

SM 2610011103 03-10:SM 2610011103 02-10 3/30/10 10:11 AM Page 10
ROCKER "ON/OFF" SWITCH
TO TURN THE TOOL "ON" depress the
dust-protected switch to the number "I" position
(Fig. 1).
TO TURN THE TOOL "OFF": depress switch
to the number "0" position.
Always hold the sander off the work when
turning the switch "ON" or "OFF". Contact the
work with the tool after sander has reached its
full speed and remove it from the work before
turning the switch "OFF". Operating in this
manner will prolong switch and motor life and
will greatly increase the quality of your work.
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with a
W RNING
dust canister, empty it
frequently, after completion of sanding and
before storing the sander. Be extremely
careful of dust disposal, materials in fine
particle form may be explosive. Do not throw
sanding dust on an open fire. Combustion
from mixture of varnishes, lacquers,
polyurethane, oil or water with dust particles
can occur if there is a static discharge, spark
introduced in the box, or excessive heat.
FIG. 9
EXCESSIVE
PRESSURE
OPTIM L
PRESSURE
Operating Instructions
Your tool is equipped with pressure control
indicator lights. The indicator lights will let you
know if you are applying the proper amount of
pressure during operation. If the green
indicator lights are illuminated you are applying
the correct amount of pressure. If the red
indicator light illuminates you are applying too
much pressure and you need to apply less
pressure (Fig. 9).
Pressure control feature is intended for use
with standard Delta backing pad.
To remove dust canister, simply pull away from
the tool (Fig. 9).
To install dust canister, align dust port with
hole in canister and push canister onto tool.
Knock excess dust out of the microfilter, or
remove dust with your fingers or a soft brush.
You may notice that all the dust may not
come out of the canister. This will not affect
sanding performance but will reduce dust
collection efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
DUST PORT
-10-
PRESSURE CONTROL
REMOVING AND INSTALLING
DUST CANISTER
CLEANING AND EMPTYING
THE DUST CANISTER
MICROFILTER
DUST C NISTER
MICROFILTER