Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SM 2610011103 03-10:SM 2610011103 02-10 3/30/10 10:12 AM Page 14
If an extension cord is
W RNING
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-
wire extension cords that have 3-prong plugs
and receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
* (8) Attachments
* (32) Pieces of abrasives
* (1) Carrying bag
Read instruction manual first! Remove plug from the power source before
W RNING
making adjustments or assembling accessories.
TROUBLE: TOOL WILL NOT START
PROBLEM
1. Power cord is not plugged in.
2. Power source fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
REMEDY
1. Plug tool into power source.
2. Replace fuse or reset tripped circuit breaker. (If the product repeatedly causes
the circuit or fuse to trip/blow, discontinue use immediately and have it serviced by
an Authorized Skil Service Center or Service Station.)
3. Inspect cord for damage. If damaged, have cord replaced by an Authorized Skil
Service Center or Service Station.
4. Have switch replaced by an Authorized Skil Service Center or Service Station.
TROUBLE: TOOL DOES NOT COME UP TO SPEED
PROBLEM
1. Extension cord has insufficient gauge or is too long.
2. Low house voltage.
REMEDY
1. Replace with adequate extension cord (Page 14).
2. Contact your electric company.
Accessories
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Tool's
Ampere
Rating
3-6
6-8
8-10
10-12
12-16
(*= standard equipment)
(**= optional accessories)
Trouble Shooting
-14-
Wire Sizes in mm
Cord Size in A.W.G.
Cord Length in Feet
Cord Length in Meters
25
50
100 150
15
18
16
16
14
0.75 0.75 1.5
18
16
14
12
0.75 1.0 2.5
18
16
14
12
0.75 1.0 2.5
16
16
14
12
1.0 2.5 4.0
14
12
—
—
—
2
30
60
120
2.5
4.0
4.0
—
—
—
—
Publicité
Table des Matières
