Battery Information; Energizer Maintenance - Tru-Test 0.15J Manuel De L'utilisateur

Battery information

Battery charging
The solar panel can fully charge a flat battery in
two weeks, provided the energizer is switched
off and there is adequate sunlight. The battery
can also be charged using a 12 V battery charger
suitable for charging rechargeable, lead-acid
batteries. This should have an output voltage of
13.8 V and output current not exceeding 1 A.
When fully charged, the battery should be able
to power the energizer for over three weeks
(0.15 J model) or two weeks (0.5 J model) with
no sunlight.
Warning!
The battery must be disconnected
and removed from the energizer before
connecting it to a battery charger.
Replacing the battery
If a replacement battery is required, use a 12 V,
7 Ah, rechargeable lead-acid battery (suitable for
all models). Do not use a non-rechargeable
battery.
Do not dispose of the battery in a land-fill or in a
fire.
In the event of a spill or leakage from a lead-
acid battery:
Contain small spills with dry sand, earth

and vermiculite. Do not use combustible
materials. If possible, carefully neutralise
spilled acid with soda ash, sodium
bicarbonate, lime, etc.
 Wear acid-resistant clothing, boots, gloves
and a face shield.
Do not let acid get into the sewerage

system.
 Neutralised acid must be managed in
accordance with approved local, state and
federal requirements. Consult your state
environmental agency and/or federal EPA.
Removing and inserting the battery
To remove and insert the battery:
1 Open the battery compartment. See step 1
of the procedure
page 3.
2 Disconnect the red and black leads
connecting the battery to the energizer.
3 Lift out the battery.
4 Install the recharged or replacement
battery. See steps 2-5 of the procedure
Installing the battery
Caution!
When connecting the battery, be
careful not to short-circuit the supply terminals.

Energizer maintenance

Clean the solar panel regularly with a soft cloth
using glass cleaner or a mild solution of
detergent and water. This will ensure the solar
panel functions efficiently.
When transporting the energizer, protect the
solar panel to prevent the glass surface from
being damaged.
Installing the battery
on
on page 3.
5