Battery Protection Mode - Tru-Test 0.15J Manuel De L'utilisateur

Caution!
Make sure the connecting leads drop
downwards from the energizer to prevent water
from collecting at the terminals.
Operation
Switching on and off (0.15 J model
only)
1 To switch on, press and hold
pulse indicator light gives one long flash.
2 To switch off, press and hold
pulse indicator light gives five short flashes.
Switching on and off (0.5 J model
only)
1 To switch on, press and hold
pulse indicator light stays flashing,
indicating an output pulse.
2 To switch off, press and hold
pulse indicator light stops flashing.
Pulse indicator light
The pulse indicator light flashes once for each
output pulse.
4

Battery protection mode

An intelligent battery management feature puts
the energizer into Battery protection mode when
battery charge falls below a 'safe operating
level'. When in Battery protection mode, the
energizer is still on, but it will not deliver a pulse
to the electric fence.
The energizer will resume delivering pulses when
the solar panel has charged the battery so that it
is above the 'safe operating level'.
Alternatively, the battery can be disconnected,
recharged with a battery charger, then returned
to the battery compartment and reconnected.
Run time extension (0.15 J model
only)
The output pulse speed varies according to the
battery charge level:
until the
until the
Run time extension (0.5 J model only)
To maximise the duration before the energizer
until the automatically switches off, the energizer
progressively decreases the pulse speed and
output energy. The operating mode is
determined by a combination of:
until the



Battery charge level
Normal
Low
the current battery voltage
the sunlight available to charge the
battery, and
long term averages of each to determine
seasonal effects.
Typical pulse rate
A pulse every 1.5 seconds
A pulse every 3 seconds