Health O Meter PRO PLUS 2101KL Mode D'emploi page 5

5. Press the ON/OFF button to turn the scale on. The display will show "Health o Meter
Pro Plus" and then "000
6. Place a weight [not to exceed the capacity] on the scale. The display should read
"WEIGHING" until the weight calculation is complete and the weight is displayed.
7. Press the KG/LB button to select the weight mode (Lb/Kg).
8. Press the REWEIGH button; the scale should perform the weighing process again.
9. Remove the weight from the scale, the scale will return to zero and the display will read
"ZERO" on the left upper side of the screen along with
10. Disconnect the scale's AC adapter from the power source. The scale will shut off. Press
On/Off and the scale will switch to battery power.
NOTE: If the set up procedure failed, refer to the troubleshooting instructions. If the problem is
not corrected, refer to qualified service personnel.
(a)
To adjust the display backlight and/or contrast, please refer to page 12.
(b)
To change the display mode in pounds to fractions or decimals, please refer to page 6.
Replacing Batteries
(refer to the Parts List on page 20 for details on parts followed by
1. Unplug the scale.
2. Remove the battery cover from the display assembly.
3. Disconnect battery holder cable connector from the scale-battery connector.
4. Carefully remove the battery holder by sliding it out the display assembly.
5. Replace the batteries with new ones.**
6. Carefully position the battery holder into the display assembly.
7. Connect the battery holder cable connector to the scale-battery connector.
8. Attach the battery cover to the display assembly and install the screw.
** We recommend the use of EVEREADY Energizer
(a)
00 ".
Lb oz
Figure 1. Replacing Batteries
4
(b)
*
"000 00 ".
Lb oz
®
e2 batteries.
TM
#
)