Avoiding Fire Hazards With Built-In Appliances; Mounting Accessories; Installation Instructions; Dimensions Of The Cupboard - BOMANN MWG 3001 H EB Mode D'emploi

Avoiding Fire Hazards with Built-in Appliances

Always observe the instructions contained in the section "Installation
Instructions".
• Only use the provided installation materials when mounting your
appliance.
• When installing the microwave oven, please adhere to the dimen-
sions shown in drawing 1.
• The rear wall of the cupboard must be removed!
• There is a ventilation slot at the bottom of the mounting frame. Keep it
clear at all times.

Mounting Accessories

1 × Drilling template
8 × Screws, short
1 × Screw, long
1 × Dummy plug
2 × Standing feet
1 × Spacer (already mounted)

Installation Instructions

This microwave oven must be installed in a tall cupboard. Please note
the following instructions:
• Remove everything that is fragile from the adjacent cupboards.
• For the installation, the cupboard must meet the following conditions:
- The cupboard must not have any cracks, splinters or other dam-
ages. All joints must be stable.
- The cupboard must be designed to support at least 40 kg.
- The microwave oven must be installed at a height of at least 85 cm.
- The rear wall of the cupboard must be removed to allow sufficient
ventilation of the microwave oven.
- The side walls of the cupboard must be at least 19 mm thick.
- The installation depth of the cupboard has to be at least 550 mm.
• It is important that there is a power socket within reach of the appli-
ance´s power cable.
• Check that the mains voltage is correct before you connect the plug
to the socket. You will find the information about the appliance on the
rating label for specifications.
• Only connect the appliance to a tested socket.
• The power socket must be easily accessible so that the plug can be
quickly removed in case of an emergency.
• Important! Do not plug in the appliance until the installation has been
completed!
• Further information and instructions can be found on the drilling tem-
plate provided.
WARNING:
• Adhere to the dimensions given in the instructions.
• Only use the included installation accessories.
• Screws which are screwed in too deeply (or are too long) can dam-
age the appliance or represent a potentially fatal safety hazard.

Dimensions of the Cupboard

Prepare a built-in cupboard / niche according to the following dimen-
sional drawing Diagram 1.
42
MWG3001HEB_D_NL_F_GB_CZ_IM
1

Installation (Steps. 2 to 4)

2
• This figure is an example only. The dimensions may vary as
these depend on the thickness of the wall cabinet.
• The original drilling template is enclosed with the appliance.
Proceed as follows:
1. Check if your cabinet has a smooth, flat bottom and right
size.
2. Tape the template onto the bottom plane of cabinet. Make
sure the centre line of the template is in the middle of the
cabinet.
NOTE:
Make sure the front edge of template is even with the
cabinet front edge.
3. Make marks on the bottom plane of cabinet according to
the hole "X" of the template.
CAUTION: Do not drill holes in the bottom cabinet.
4. After make marks according to the instruction, remove the
template.
5. Mount the standing feet at the marked positions.
14.01.20