Maxi-Cosi Coral 360 Mode D'emploi page 65

EN
Coral 360 in airplanes
• Installation of the Coral 360 on an aircraft seat differs
from the installation on a car seat.
• Installing the Coral 360 with a 2-point safety belt is
only allowed when used in an aircraft.
• In an aircraft, the Coral 360 may only be used on
forward-facing passenger seats.
• The soft carrier cannot and may never be installed
stand-alone in an airplane without being locked into
the safety shell.
• To install Coral 360, place the infant carrier rearward
facing on the passenger seat. Route the webbing
of the-2point safety belt through the belt guides.
(1,2) Lock the buckle of the 2-point safety belt. (3)
And tighten the 2-point safety belt by pulling on the
tightening strap. (4)
• The handle of the Coral 360 must be in upright
position.
• The belt buckle must not be positioned between
the belt hooks of this car seat. Otherwise a safe
attachment does not exist.
• To uninstall Coral 360, open the buckle of the 2-point
safety belt by lifting the lever of the buckle. (5) And
remove the webbing of the 2-point safety belt from
the guides. Make sure the Coral 360 does not fall from
passenger seat when opening the buckle.
• The Coral 360 must remain belted on the aircraft
seat, even when unoccupied.
• The Coral 360 is only for use on an aircraft seat
authorized by the airline.
• Do not install the Coral 360 in the area of airbag
deployment.
• Instructions of the cabin crew must be followed.
The safety of your child for not complying with the
installation and instruction manual is not guaranteed.
Care
The cover, cushions, belt pads and sun canopy of
the car seat can be removed for washing. The front
baleen of the sun canopy needs to be removed before
washing. The plastic inserts of the shoulder and crotch
pads do not need to be removed before washing.
The retractable soft carrier handles and the harness
webbing can be cleaned using a wet cloth.
I I
Maxi-Cosi Coral 360 65