Delete A File Stored In The Programmer; Change Epm Programmer Internal Configuration - Lenze EEPM1RA Instructions De Mise En Service

4.12 Delete a file stored in the Programmer
With this function you delete the parameter files stored in the EPM Programmer
Press
1.
MENU
2.
ENTER
3.
4.
ENTER
5.
ENTER
4.13 Change EPM Programmer Internal Configuration
With this function, you can change the type of files that the EPM Programmer can EDIT by downloading the proper
configuration for the file you will be working with from a "Configuration EPM" loaded in the MASTER PORT.
Press
1.
MENU
2.
ENTER
3.
ENTER
4.
Tip!
• Changing the EPM Programmer's internal configuration is only required if you are going to EDIT an inverter drive
file stored in the EPM Programmer or EDIT a servo drive EPM. The Programmer must be configured for the
parameter version of the file.
• Configuration EPM's can be purchased from Lenze, AC Tech or your local distributor.
• Configuration files can be downloaded into the EPM Programmer from your PC via RS232 connection using
TECHLINK software.
The display shows...
DELETE FILE
SELECT FILE
>#DEFAULTS(400)<
)
>#ABC_ _ _ _ _(400 <
CONFIRM=[ENTER]
DELETING FILE...
FILE DELETED!
DELETE FILE
The display shows...
LOAD CFG EPM
VERIFYING MASTER
CONFIRM=[ENTER]
TRANSFERRING 0%...100%
WAIT-LOADING CFG
CFG LOADED!
LOAD CFG EPM
ENGLISH
Operation
Explanation
Press the key until the menu appears in the display.
This request is briefly shown in the display
The cursor is blinking in the display on the right.
Select the parameter file you want to delete (e.g.
ABC_ _ _ _ _).
Press the MENU key, if you want to abort the
process.
The parameter file is deleted.
The EPM programmer automatically returns to the
main menu.
Explanation
Press the key until the menu appears in the display.
The programmer verifies that the EPM in the
MASTER PORT is a valid Configuration EPM.
Press the ENTER button to confirm this action
The new configuration is loaded into the EPM
Programmer's memory and verified.
Messages are displayed briefly then the EPM
programmer automatically returns to the main
menu.
17