Switch On/Off Epm Programmer - Lenze EEPM1RA Instructions De Mise En Service

4.3 Switch on/off EPM Programmer
Switch-on with unprotected access (without password)
Press
1.
ON
2.
3.
4.
Switch-on with protected access (with password)
Steps 1...4 as above (
Press
5.
6.
ENTER
Tip!
• After the initialization, the main menu shown last is automatically called up.
• If you lose or forget your password, please contact your Lenze representative.
Switch-off
Press
1.
OFF
Tip!
• The EPM programmer automatically turns off after 5 minutes, if no operation takes place during this time.
The display shows...
EPM PROGRAMMER
INTERN CFG 400
MASTER CFG 400
MSTFILE#DEFAULTS
MASTER MISSING!
Section 4.16, Enter/change password)
The display shows...
PASSWORD?? 0000
PASSWORD?? xxxx
The display shows...
SHUTDOWN.. 5SEC
ENGLISH
Operation
Explanation
Shows the parameter version that the EPM
programmer is configured with (e.g. 400).
Shows the parameter version of the EPM (e.g. 400)
plugged into the MASTER PORT.
Shows the name of the parameter file (e.g.
DEFAULTS) stored in the EPM plugged into the
MASTER PORT.
This message is displayed, if no EPM is plugged
into the MASTER PORT.
Explanation
The cursor is blinking in the display on the right.
using the
Enter the password
If you do not enter a password, you have restricted
access to the main menus after confirmation (only
the menus CONTRAST, DISPLAY, and MASTER –>
EPM are available).
If you enter a wrong password, WRONG
PASSWORD will be displayed. If you press the
MENU key, you abort the process and get the
restricted access to the main menus.
Explanation
The shutdown process takes 5 seconds.
If you press any key within these 5 seconds, the
shutdown process is aborted
buttons
.
9