Canon imageRUNNER 1750i Guide page 13

Operating the Machine in System Management Mode
The System Manager log-in procedure varies depending on the applied
authentication mode provided by the uniFLOW integration. See the table below.
Authentication Mode
(p. EN-3)
Authentication to the
Machine
Authentication to the Login
and Document Release
NOTE
• You can give a user System Manager privileges by selecting the user type when you
register the user on the uniFLOW server. See the documentation included with the
uniFLOW software.
• When you log in to the machine as an end user, you cannot access the System
Settings of the machine and the message <Only users logged in as an administrator
can access the selected settings.> appears. To access the System Settings, once log
out of the machine and again log in as the System Manager.
Description
Log in to the machine with the user name and password, PIN
code, or ID card for the System Manager. Otherwise log-in
procedures are similar to those for end users. (See "Logging
in to the Machine," on p. EN-8.)
As you must disable both Department ID and User ID
Management (See p. EN-5), the only way to log in to the
machine as the System Manager is by entering the System
Manager ID and System Password registered in the
machine.
Managing the Machine with the uniFLOW Integration
EN-6