Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
OBSERVED FAULT
Motor does not start, no ignition
Motor starts, no ignition or cuts out
Motor starts, heater emits smoke
Heater does not stop
IF YOUR UNIT IS STILL NOT WORKING LOCATE THE NEAREST AUTHORIZED SERVICE CENTER OR CONTACT HEATSTAR AT 866-447-2194
CAUSE
No electrical current
Wrong setting of room thermostat or
other control
Thermostat or other control defective
Electrical motor defective
Electrical motor bearings defective
Burned out condenser
Electric Ignitor Defective
Flame control box defective
Photocell defective
Not enough or no fuel at burner
Solenoid Defective
Not enough combustion air
Too much combustion air
Fuel contaminated or contains water
Air leaks in fuel circuit
Not enough fuel at burner
Too much fuel at burner
Solenoid defective
Fuel Fired Portable Radiant Construction Heater
REMEDY
Check main power supply
Check proper positioning and function of switch
Check fuse
Check correct setting of heater control. If thermostat,
make sure selected temperature is higher than room
temperature
Replace control device
Replace motor
Replace motor
Replace condenser
Check connection of H.T Leads to electrodes and
transformer
Check electrodes setting
Check electrode for cleanliness
Replace H.T. transformer
Replace control box
Clean or replace the photocell
Check state of motor-pump plastic coupling
Check fuel line system including fuel filter for possible leaks
Clean or replace oil nozzle
Check electrical connection
Clean or replace solenoid
Make sure Air inlet and outlet are free
Check settings of combustion air flap
Clean burner disc
Check settings of combustion air flap
Drain fuel in tank and replace with clean fuel
Clean or replace oil filter
Check fuel line and filter for possible leaks
Check pump pressure
Clean or replace fuel nozzle
Check pump pressure
Replace nozzle
Replace solenoid
6
Operating Instructions and Owner's Manual
Publicité
Table des Matières
