SAFETY AND NOTICES
Important safety note:
Make sure that work on your electrical cabling and the associated connection work is only carried out by a qualifi ed
specialist.
AREAS OF APPLICATION / USE
ON PRIVATELY USED GATES
– Alterations and deviations from the illustrations as well as printing errors are reserved.
– The performance of the actuator systems may be infl uenced by various factors such as specifi c on-site construction and
conditions. No claims may arise based on the technical information as this may differ in individual cases.
GENERAL SAFETY REGULATIONS / SAFETY NOTES FOR THE INSTALLER
– CAUTION! To ensure the safety of persons, the instructions must be carefully read before proceeding with the installation
of the product. An incorrect installation or faulty operation of the product can cause serious personal injury.
– The packaging material (plastic, styrofoam, cardboard) may not be stored within the reach of children since it poses a po-
tential source of danger.
– The instructions must be stored carefully for future reference.
– This product has been exclusively developed and manufactured for the application purposes described in this document.
Any other use that is not explicitly stated, could affect the integrity of the product and/or represent a source of danger.
– Schellenberg disclaims all liability for damages caused by improper or incorrect use of the actuator system.
– The device may not be installed in explosion-prone environments. The presence of fl ammable gases or fumes represents a
severe safety risk.
– The mechanical parts must be conform with the requirements of the standards EN 12604 and EN 12605.
– Countries that do not belong to the European Union, are responsible for ensuring an appropriate level of safety according
to national legal provisions beyond those defi ned by the above mentioned standards.
– Schellenberg will not assume any liability for a non-professional manufacturing of the locking devices to be actuated, as
well as for deformations that may arise during the operation.
– The installation must be carried out in accordance with the standards EN 12453 and EN 12445. The force setting of the
automatic module must be adapted to the gate. The actuator has a built-in safety device to prevent crushing injuries which
consists of a torque control. In any case it is necessary to adjust the torque control to the gate appropriately.
– After hitting an obstacle the actuator will reverse direction.
– Level 4 is the factory programmed the force setting.
– The safety devices (EN 12978 standard) allow the securing of potentially hazardous areas and protect against mechanical
movement risks, such as crushing, dragging, and shearing injuries. During the programming of the force setting the safety
shut-off will not be active.
– Before attempting any work on the system, the electrical power supply should be disconnected.
– For each system it is recommended to use at least one light signal as well as a one light barrier.
– Schellenberg disclaims any liability regarding the safety and smooth operation of the system, if components are used on
the system that were not supplied by Schellenberg.
– The components that are part of the drive system are not allowed to be altered in any way.
– The installer must hand over all information to the operator of the system which concern the manual operation of the sys-
tem during emergencies as well as these installation instructions which were supplied with the product.
– Neither children nor adults are allowed to dwell in the immediate vicinity of the gate system during operation.
– The remote controls or other impulse transmitters must be kept out of reach of children to prevent accidental activation of
the actuator.
– A passage between the gate leafs is only allowed when the gate is fully open.
– The operator should not perform any repairs or execute direct intervention to the system and only utilize qualifi ed service
personnel to do so.
– Do not dispose of used batteries in the domestic trash! Appropriate collection-boxes are available in certain retailer localities.
– All procedures that are not expressly provided in these instructions are not permitted.
9