Before You Start - Cooke & Lewis 5059340123318 Mode D'emploi

Use
Utilizare
Control Panel
1 2
1. Power Button 2. Program Delay Button 3. Program Select / Child Lock Button 4. Function Button 5. Program
Indicators 6. Dry Plus Indicator 7. Salt Refill Indicator 8. Rinse Aid Refill Indicator 9. 3-In-1 Indicator 10. Child Lock
Indicator 11. Display

Before you start

Remove all packaging materials from the dishwasher.
Connect the plug to the power supply and switch on; the dishwasher will beep once and you are ready to set up for
first use.
Follow these steps to set up your dishwasher for first use.
Before using your dishwasher for the first time you must:
1. Set the water hardness to suit your local water supply.
2. Fill the salt container with dishwasher compatible salt.
3. Fill the rinse aid container with dishwasher compatible rinse aid.
4. Add dishwasher powder or a capsule suitable for the first wash.
01 Water Hardness
The water softener is designed to remove minerals such as calcium carbonate from the water supply, which would have a
detrimental effect on the operation of the appliance. The higher the content of these minerals, the harder the water is. The softener
should be adjusted according to the hardness of the water in your area. Please contact your local water utility company for the
hardness of the water in your area.
Setting the water hardness
The appliance water hardness can be set from H0 (very soft) to H7 (very hard).
Dishwasher salt is not required for very soft water at H0.
1. Determine the water hardness from your local water utility company. This information is often found on their website by searching
with your post code.
2. There are many different methods for reporting water hardness dependent on your local country. The most common versions are
found in the Water Hardness table below.
3. Determine the correct appliance setting (H0 - H7) from the Water Hardness Table using the information from your local water
utility company. If your water hardness scale is not captured in the table, conversion charts are available on the internet.
4. Close the door.
5. Press the Power button
6. Hold down the Program Select button
beep and H4 flashes in the display.
7. Press the Program Delay button
increasing again. There will be a single beep for each press.
8. Finally press the Program Select button
GALA13082-01_209193_s1_s1_60cm built-in dishwasher IM V31120 BX220IM V3R.indd 22
Utilisation
Uso Utilização
11 7 8 10 9
to turn on the appliance.
, then press and hold the Program Delay button
to set the required level. Note: when the setting reaches H7 it will then go back to H0 before
once to store, and there will be a single beep to confirm the setting.
Eco Eco
5 6 3
Eco
for 5 seconds until you hear a single
22
4
10/11/2020 12:18