Thermador Masterpiece MEDS301WS Mode D'emploi page 45

DO NOT touch the glass of the new replacement bulb
9.
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder, gen-
tly poking until the two prongs locate in the ceramic
socket.
Press down to seat the bulb.
10.
Put the glass lense cover back on by inserting it into the
11.
mounting clip and pressing the end nearest you into the
housing until it locks into place. Insert the screw through
the glass lense cover and tighten.
Reinstall the oven rails.
12.
Turn on the circuit breaker.
13.
Recalibrating the steam oven
The steam oven automatically calibrates to adjust to the
pressure conditions in your area the first time steam is
used at 212°F (100°C). If you should move, you can re-
calibrate the steam oven manually to ensure that it auto-
matically adjusts to your new location. Recalibration is not
necessary after a power failure.
Requirement: The oven cavity is cool.
Fill the water tank.
1.
Remove the accessories from the steam oven cavity.
2.
Wipe the smooth surfaces in the oven cavity with a soft,
3.
wet cloth.
Set the heating mode and temperature.
4.
Heating mode Steam
Temperature 212°F (100°C)
Duration 30 minutes
Switch off the appliance after the specified cooking time
5.
by pressing ON I OFF.
Cleaning and maintenance en-us
45