Fein ASCD12-100W4 Serie Mode D'emploi page 20

en
20
Symbol, character
*
(**)
***
(Ax – Zx)
Character Unit of measurement,
international
U
V
f
Hz
n /min, min
0
n /min, min
S
M... Nm
inch
inch
Ø mm
L dB
pA
L dB
wA
L dB
pCpeak
K...
2
m/s
2
m/s
h
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Explanation
Charger type
Weight according to EPTA-Procedure 01
Low speed
High speed
Torque gradient for applications with hard backing, e. g., screws with nuts and
washers (dependent of screw diameter and strength)
Torque gradient for resilient applications, e. g., wheel rims, spring washers, disc
springs, stud bolts, extensions
Torque gradient for applications with soft backing, e.g., wood (dependent of screw
diameter and length), lead or fibre discs
The power tool can additionally be operated with deviating performance data in the
12 V and 14.4 V voltage classes.
may contain numbers and letters
Partially in delivery scope
Marking for internal purposes
Unit of measure-
ment, national
V
Hz
-1
, rpm, r/min rpm
-1
/min
Nm
inch
inch
mm
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
Explanation
DC voltage
Frequency
No-load speed (with fully charged battery)
Impact rate
Torque (hard screwdriving application)
Hexagon socket tool holder
External square tool holder
Diameter of a round part
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to EN 62841
(vector sum of three directions)
Arithmetic mean value of the vibration total values
Basic and derived units of measurement from the
international system of units SI.
2
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.