Sony VPL-CH375 Guide De Référence Rapide page 50

Correcting trapezoidal distortion of the projected image (Keystone feature)
If the image becomes trapezoidal, set the keystone manually.
When the projected image is a trapezoid, tapering to the top or bottom
1 Press KEYSTONE on the remote commander once or select V Keystone in the INSTALL
SETTING menu.
2 Use V/v/B/b to set the value. The higher the setting, narrower the top of the projected image.
The lower the setting, the narrower the bottom.
Press the RESET key to restore the projected image before adjustment.
When the projected image a trapezoid, tapering to the right or left
1 Press KEYSTONE on the remote commander twice or select H Keystone in the INSTALL
SETTING menu.
2 Use V/v/B/b to set the value. The higher the setting, the narrower the right part of the
projected image. The lower the setting, the narrower the left part.
Press the RESET key to restore the projected image before adjustment.
Notes
• Since the Keystone adjustment is an electronic correction, the image may be deteriorated.
• Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
20
GB
Projecting an Image
Increase the number
towards plus
Increase the number
towards minus
Increase the number
towards minus
Increase the number
towards plus