LGB 65000 Instructions De Service page 10

Hint: If, with analog operation, the
starting signal sounds for the wrong
direction, swap the wires for the
power supply at the Sound Unit to
reverse the polarity.
65004 European Electric Loco
Sound Unit
This Sound Unit replicates the typical
sounds of a European electric loco-
motive. When the throttle is turned
up slowly, you hear the main switch
and then the compressor. The whis-
tle sounds when the loco starts. After
the loco stops, you hear the main fan
and then the main switch.
Power Supply
Attention! For safety and reliability,
operate this product with LGB power
supplies (transformers, power packs
and controls) only. The use of non-
LGB power supplies will void your
warranty.
Use this product with LGB power
supplies with an output of at least 1
amp. For more information on LGB
power supplies for indoor, outdoor
and multi-train operation, see the
LGB catalog.
INSTRUCTIONS FOR ADVANCED
USERS
MTS Sound Decoder
Programming functions
You can program numerous func-
tions of the sound decoder to suit
your requirements. If you want to do
this, program the "function values"
in "registers" (CVs) using a PC and
the 55045 MTS
Programming Module. You can also
program the function values using a
55015 Universal Remote.
PC Decoder
Hints:
- For normal operation, it is not nec-
essary to change the function val-
ues.
- If programming results in unsatis-
factory operation, you can repro-
gram the factory pre-set values of
most important CVs: Program reg-
ister CV55 to function value 55.
This also reprograms the loco
address to the factory pre-set
value.
To reprogram the factory pre-set
function values with the 55015 (dis-
plays shows "P --") input 6, 5, and 5
and press the right arrow button. The
display shows "P --" again: Input 5,
5, and 5 and press the right arrow
button again.
13