Microsoft Xbox 360 Mode D'emploi page 6

    c onnectthePedalBasetothe
racingWheel
RJ-11 port RJ-11 port
Pedal left Pedal left
To connect the pedal base to the racing
wheel, connect one end of the RJ-11 cable
to the RJ-11 port on the pedal base and the
other end to the port on the back of the racing
wheel. wheel.
To streamline your system's appearance,
thread both the RJ-11 cable and the power
cord (if used) through the cable-management
area on the underside of the pedal base.
n OTE
The racing wheel requires a straight-through
RJ-11 cable (included). Do not use a crossover
RJ-11 cable with the racing wheel.
  
Pedal right Pedal right
Caution
You might accidentally pinch your foot if
you use the pedal base when not wearing
shoes. Wear appropriate footwear while
using the pedal base.
    a ttachthetableclamp
The racing wheel can be used for either lap
or table mounting. The table clamp stabilizes
the wheel during gameplay—especially
convenient when force feedback is engaged.
Release button Release button Release button
Quick-release lever Quick-release lever
To attach the table clamp:
    1   Loosen the clamp's screw and make sure
the quick-release lever on the front of the
clamp is open (not pressed fl at), then slide
the clamp onto the edge of your table. Take
care not to pinch your fi ngers.
       Hand-tighten the screw until the fi t is snug.
Do not overtighten the screw, as this may
damage the table surface.
    3   Push the quick-release lever fl at.
3 3
Screw Screw Screw
1 1
2 2
6