Nailer Operation - Hitachi NP 35A Manuel D'instructions Et De Sécurité

English
(2) 1 Place the nails against the magazine
guide surface and insert the tips of
the nails as far as they will go into the
groove in the magazine.
2 Feed the nails in the magazine into the
blade guide with your fi ngers.
Nail
2
Groove
Blade guide
(3) Push the back-end of the magazine cover
forward and check that the nails do not
protrude from the magazine guide surface
before closing the magazine.
NOTE
○ Load the nails with the tips facing toward
the groove in the magazine.
○ Do not load nails of diff erent lengths.
○ Nails between 15 mm and 35 mm long
can be used in this Nailer without any
adjustment, but whatever length they are,
make sure that the tips of the nails are
inserted as far as they will go into the groove
in the magazine.
Magazine
Nail
Bottom of groove
The Nailer is now ready to operate.
12
1
Magazine
Guide surface
Tip
Gap

NAILER OPERATION

Read section titled "SAFETY" (pages 4 –
6).
● Choice of triggering method is
important.
Please read
"Methods
below.
● Never place your face, hands or feet
near fi ring head when using.
● Do not drive nails on the top of other
nails or with Nailer at too steep of
an angle; nails can ricochet and
hurt someone.
● In order to avoid double fi re or
unwanted ejection of a nail due to
bouncing of the Nailer.
1) release trigger quickly when
performing trigger fi re.
● Do not drive nails into thin boards
or near corners and edges of
workpiece. Nails can be driven
through or away from workpiece
and hit someone.
● Never drive nails from both sides of
a wall at the same time. Nails can be
driven into and through the wall and
hit a person on the opposite side.
DANGER
● Operators
others in work
area must wear
safety glasses
with side shields
which conforms
to ANSI
specifi cations.
WARNING
● Never point tool
at yourself
others in work
area.
● Keep fi ngers
away from trigger
when not driving
nails to avoid
accidental fi ring.
and understand
of operation" found
and
Z87.1
or