Nailer Operation - Hitachi NR 90AD Manuel D'instructions Et De Sécurité

English
(3) Pull the nail feeder (B) back to engage the nail feeder
(A) to the nail strip.
Nail Feeder (A)
NOTE
● Quietly push the Nail Feeders (A) and (B) against the
nail.
If the Nail Feeders (A) and (B) are released from
backward the magazine and bumped against the nail,
the connecting paper of the nail can be damaged.
● Use nail strip of more than 5 nails.
The Nailer is now ready to operate.
Removing the nails:
1 Pull the nail feeder (B) backward.
2 Return the nail feeder (B) forward quietly while
pushing the nail feeder (A).
3 Push the nail stopper toward the magazine side, and
pull out nails from the back of the magazine.
14
Nail Feeder (B)
5
1
Nail Feeder (A)
Nail Feeder (B)
2
Nails

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 7).
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from trigger when not driving
nails to avoid accidental fi ring.
● Choice of triggering method is important.
Please read and understand "Methods of
Operation" below.
● Before starting work, check the nailing operation
switching device.
This Hitachi nailer includes a nailing operation
switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
● Never place your hands or feet closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive nails on the top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and hit
someone.
Nail Stopper
3
DANGER
MUST wear
WARNING
safety