Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. REMOVE BAFFLE FILTERS, GREASE DRIP RAIL
AND ELECTRICAL COMPARTMENT COVER
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the center one(s).
B. Remove tape on grease drip rail (1). Lift out grease drip rail and set aside.
Remove electrical compartment cover (2).
A
HD1023
5. REMOVE KNOCKOUT OPENING
Punch out the electrical knockout hole on the back of the
hood. Install the wire clamp (included in parts bag).
6. INSTALL ADAPTER
Remove adapter from inside hood.
Using both no. 8 x 3/8" zinc-plated screws from parts bag,
assemble the adapter on the top of the hood.
Seal all joints with metal foil duct tape to eliminate air
leaks.
B
HR0073
M
OUNTING SCREW LOCATIONS
HJ0069
6
1
2
Publicité
Table des Matières
