Mon Button (Monitor); Scanning All Channels; Display Backlight; Keypad Lock - Midland XT70 Manuel D'utilisation

Transmitting TOT Setting
The TOT function is used to prevent a too long transmission. This function
temporarily blocks transmissions if the radio has been used beyond the
maximum time permitted. Once reached the preset timer (1 minute), the radio
will be forced in reception mode.

MON button (Monitor)

The Monitor button is for temporarily excluding (opening) the squelch, in order
to listen to signals that are too weak to keep the squelch permanently opened.
By excluding the squelch you will avoid listening the communication "chopped"
by the squelch. In order to activate the Monitor function, so as to listen to
all traffic on the selected channel, keep pressed the MON/SCAN button for
about 3 seconds. Keep pressed the button MON/SCAN for about 3 seconds
to disable this function.

Scanning all channels

XT70 can automatically search for signals throughout the PMR/LPD bands by
scanning, i.e. selecting the channels in rapid sequence.
Press briefly the button MON/SCAN to start scanning.
When a signal is detected, the scanning pauses on that channel and you can
transmit by pushing PTT . The scroll buttons ▲/▼ allow you to change the
direction of scanning (from lower channels to higher ones or vice versa) and
therefore to skip communications which are of no interest.
If you want to stop it, press again MON/SCAN. Your transceiver will go back
to the channel from which the scanning originally started.

Display backlight

If there is insufficient light to read the display you can press the MENU button
to switch the display back light on for about 5 seconds.
Switching the backlight on the display adds an additional drain on the batteries.
Try to make a moderate use of this.

Keypad lock

Keep pressed CALL/ for about 3 seconds and
mation. Only PTT and CALL/ remain active. To disable this function, keep
pressed again CALL/ for 3 seconds approx.
XT70 user's manual
will be displayed as confir-
| 9