Krups EA9000 Serie Mode D'emploi page 31

Choosing the volume.
n
The screen displays the last volume requested. You can modify this
n
volume using the arrows on the left and right of the indicated value.
2
Place your cup under the coffee nozzles.
n
To use a large cup (or mug), you must remove the small drip tray.
n
Make sure that the cup fits under the coffee nozzles without
interference.
The cup must be placed close to the cleaning container.
n
3
Caution: use a cup that matches the volume of the recipe. The
n
maximum height of the cup is defined by the coffee nozzles; do not
tilt the cup to place it under the coffee nozzles.
Caution: Do not push the frothing nozzle (11) with the cup; otherwise,
n
it might break off.
Press OK. The steam nozzle then comes out of its cleaning
n
container to stop just above your cup.
You will need to modify the steam nozzle position using the + and -
n
symbols according to your convenience. If the steam nozzle is too high
from the bottom of the cup, there is a risk of splashing. Caution: The
4
nozzle must not touch the bottom of the cup either.
Press the OK button on the touch screen.
n
Dispensing hot water through the steam nozzle.
n
If necessary, the machine goes into preheating mode, then begins to
n
dispense hot water.
You can modify the volume of your preparation using the arrows on
n
the left and right of the indicated value.
Press "Stop" to stop the recipe.
n
5
!
Important: The production of hot water does not stop immediately after you press the
(it takes 3 to 5 seconds to stop). Press the button sufficiently early to avoid overflows.
ENGLISH
"Stop" button
29