Krups EA9000 Serie Mode D'emploi page 49

Masquer les pouces Voir aussi pour EA9000 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PROBLEM / MALFUNCTION
Nozzle cleaning does not take
place properly.
The water tank has been filled,
but the warning message is still
displayed on the screen.
The drip tray has been emptied,
but the warning message is still
displayed on the screen.
The used coffee collector has
been emptied, but the warning
message is still displayed on the
screen.
A power failure occurs during
the cycle.
There is water underneath the
appliance.
!
Note:
Programming problems are often resolved by unplugging the appliance for about one minute and
then plugging it in again.
Danger:
Only a qualified technician is authorised to carry out repairs on the power cord and the
220 - 240V electrical system. Failure to respect this exposes you to fatal injuries due to
the presence of electricity! Do not use an appliance that is visibly damaged!
PROBABLE CAUSES
No cleaning liquid.
n
The milk used is not suitable.
n
The water tank is not fitted
n
properly.
The float at the bottom of the tank
n
does not move freely.
The water tank is scaled up.
n
The metal contacts are dirty.
n
The used coffee collector is not
n
fitted properly.
The used coffee collector has
n
been fitted back too quickly.
The drip tray is not correctly fitted
n
or is overflowing.
ENGLISH
CORRECTIVE ACTIONS
Check that your preparation does
n
not boil while heating or frothing.
If it does, reduce the heating
and/or frothing time.
Check that the cleaning liquid
n
bottle is not empty.
Carry out a manual cleaning.
n
We recommend that you use cold
n
milk.
Check and unblock the float if
n
necessary.
Reinstall the water tank properly
n
until you feel some resistance.
Rinse the water tank under
n
running water and descale, if
necessary.
Clean and wipe the metal
n
contacts at the back of the drip
tray.
Refit the used coffee collector.
n
Wait for at least 8 seconds before
n
refitting the empty collector.
The appliance is automatically
n
reinitialized when it is switched
back on.
Check that the drip tray has been
n
fitted correctly and empty it if
required.
47

Publicité

Table des Matières
loading

Table des Matières