V-Wd-9 Model; V-Wd-24 Model; Use Of Squeegee Attachment Kit (Optional - V-Wd-24 Model); Dry Vacuuming - Tennant V-WD-9 Manuel D'utilisation

MACHINE SETUP
OPERATION

V-WD-9 MODEL

1. Plug power cord into a grounded outlet.
2. Connect vacuum hose to the machine.
3. Select desired accessory tool and connect
to vacuum hose.

V-WD-24 MODEL

1. Before operating, attach the cord restraint
to the handle and loop the extension cord
through the cord restraint as shown.
2. Inspect power cords for damage before
each use. Replace cords immediately if
damaged.
3. Connect the supplied extension cord into
a grounded 3 hole electrical outlet. No
adapter should be used with the machine.
Do not remove, bend or modify ground
pin. Do not use additional extension cords.
4. Connect the vacuum hose to the machine
5. Select desired accessory tool and connect
it to the vacuum hose.
AND USE OF SQUEEGEE ATTACHMENT
KIT (OPTIONAL - V-WD-24 MODEL)
Kit Part Number KTRI06192
1.
clear of debris.
2. Connect the vacuum hose to the squeegee
assembly.
3. Loop the hose and attach it to the plastic
clip.
4. Lift foot pedal with toe to release squeegee
from raised position.
5.
To obtain optimal drying performance,
Turn knobs counterclockwise to raise or
clockwise to lower blades.
6. Turn the motor switch on.
7. Pull the machine backwards to pick up
liquid.
8. Clean squeegee blades after each use.
9.
when machine is not in use to prevent
blade set.

DRY VACUUMING

1. Make sure the tank is dry, otherwise dry it
with a rag before inserting main polyester
2.
it's not already in place).
3. Mount the head on top of tank and lock it
with latches.
4. If your vacuum is equipped with paper or
5.
as normal.
TENNANT V-WD-9 / V-WD-24
EN
9