Hanging The Fan - Kichler Spyn LED 52 Manuel D'utilisation

HANGING THE FAN

REMEMBER
to turn o the power before you begin installation. This is necessary
Outlet Box
for your safety and also the proper programming of the control system.To properly
install your ceiling fan, follow the steps below.
Mounting
Bracket
Flat Washer
Screw
Step 1
. Before attaching fan to outlet box (not included), ensure the outlet box is Fig. 5
securely fastened to at least two points to a structural ceiling member (a loose box
will cause the fan to wobble). Pass the 120 volt supply wires from the ceiling outlet
box through the center of the ceiling mounting bracket. Install mounting bracket to
outlet box in ceiling using the screws and washers included with the outlet box or
Hanger Ball
screws and washers in the hardware bag. (Fig. 5)
Set Screw
Cross Pin
Step 2. Remove the hanger ball from downrod assembly by loosening set screws ,
Downrod
removing the cross pin, and sliding ball o the rod.( Fig. 6)
Fig. 6
52" Spyn LED 7