Hanging The Fan - Kichler Rana 310155 Manuel D'instructions

5. HANGING THE FAN

REMEMBER to turn off the power before you
begin.
To properly install your ceiling fan, follow the
steps below.
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counterclockwise. (Fig.5)
Step 2. Remove the ceiling mounting bracket
from the canopy by removing (and save) one of
the two screws. Loosen the remaining screw by
a half turn. (Fig.5)
Step 3. Pass the 120 volt supply wires from
the ceiling outlet box through the center of the
ceiling mounting bracket. (Fig. 6)
Step 4. Attach the ceiling mounting bracket to
the outlet box using the screws and washers
included with the outlet box. (Fig. 6)
Step 5. Remove and discard the three screws
securing the plastic stabilizer on the bottom of
motor housing. Remove and discard the plastic
stabilizer. (Fig. 7)
Step 6. Remove the hanger ball from the
downrod assembly by loosening the setscrew,
removing the cross pin and turning the ball off
the downrod. (Fig.8)
Canopy
Canopy cover
UL Listed
outlet box
Ceiling
mounting
bracket
Hook
120V Wires
Plastic Stabilizer
Screws
Cross pin
Hanger ball
Downrod
60" Rana
™
Fig. 5
Washers
Mounting screws
(supplied with
electrical box)
Fig. 6
Fig. 7
Set screw
Fig. 8
4