Kichler Spyn LED 52 Manuel D'utilisation page 8

HANGING THE FAN
Step 3. Loosen the two set screws and remove the clip and cross pin from the top
coupling of the motor body.Carefully feed the fan wires and safety cable up through
the downrod. Thread the downrod onto the motor coupling until the cross pin holes
are aligned. Next, replace the cross pin and clip, and tighten both set screws. (Fig. 7)
Step 4. Slip the coupling cover, canopy hole cover and canopy onto the downrod.
Carefully reinstall the hanger ball onto the downrod . Make sure the cross pin is in
the correct position and the set screw is tight and the wires are not twisted . ( Fig. 8)
Step 5 . Now lift the motor body into position and place the hanger ball into the mounting
bracket. Rotate until the "Check Tab" has dropped into the "Registration Slot " and
seats firmly. ( Fig. 9) The entire motor body should not rotate if this is done correctly.
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling fan during
operation.
8
Downrod
Clip Clip
Set Screw
Set Screw
Cross Pin
Motor Body
Fig. 7
Hanger Ball
Canopy
Canopy Hole Cover
Coupling Cover
Fig. 8
Mounting Bracket
Registration Slot
Hanger Ball
Fig. 9
Cross Pin
Cherk Tab