Table des Matières
Publicité
SIMPLEX
ORIENTATION
The procedure detailed in the following
instructions refer to the right and left side, and
the top and bottom of the machine as shown.
Fig. 1
A. UNPACKING/CHECK OF CONTENTS
Items packed loose in the box include:
1.
Straight Cutting Head
2.
Bevel Cutting Head
3.
27" Squaring Arm
4.
Mat Guide
5.
Aluminum Guide Channels (2)
6.
Channel Screws (4)
7.
Guide Rail Stops (2)
8.
Squaring Arm Stop (1)
9.
Logan Screwdriver
10. Five Pack of #270 blades
11. #750 Base Board (not shown)
12. Slip Sheet (not shown)
13. Instruction Manual (not shown)
If there are any missing or damaged items please call customer service
immediately at 1-800-331-6232
B. ASSEMBLY
Mat Guide
1. Press each aluminum mat guide channel into board
slots with rounded end towards the Guide Rail.
Insert the four small guide rail channel screws from
the UNDERSIDE of the board and tighten. Fig. 3
2. To install the Mat Guide loosen each knob three full
turns. Hold the mat guide at either end and evenly
drop the Mat Guide into the aluminum channels and
tighten the knobs.
3. To loosen, turn knobs counterclockwise and slide.
Fig. 4
Squaring Arm
Use the line-up tool found in the squaring arm slot to line up
the slot in the board with the slot in the squaring arm. Use the
two larger machine screws provided to tighten the squaring
arm into the board slot. These machine screws are found
screwed into the board for shipping purposes. Fig. 4
Slip Sheet
A Slip Sheet is a piece of scrap matboard placed underneath
the mat to be cut when bevel cutting. The Slip Sheet must be
at least as long as the mat being cut and at least 4" wide. This
protects the blades while cutting and produces a better cut.
Fig. 5
NOTE: It is important not to continue to cut in the same
spot of the Slip Sheet as this can cause curves in the
cut. Replace Slip Sheet as necessary.
3
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
PLUS
Fig. 1
Top
Right
Left
Bottom
Fig. 2
1.
Fig. 3
Fig. 4
M A T C U T T E R
3.
5.
8.
2.
Line-Up Tool
Fig. 5
M O D E L S 7 5 0 & 7 6 0
4.
6.
10.
9.
Fig. 4
Slip Sheet
Mat Board
7.
Publicité
Table des Matières
