Cutting A Beveled Opening Using One Production Stop - Logan Professional Serie Manuel D'utilisation

SIMPLEX
C. CUTTING A BEVELED OPENING USING ONE PRODUCTION
STOP
EXAMPLE: Cutting a mat with a 2" border.
1. Set the Mat Guide to the desired border width. For example, for a 2"
border, align the front of the Mat Guide at the 2" mark and tighten the Black Knobs. Fig. 1
2. Place the mat to be cut into the machine colored side down with the
Slip Sheet underneath and lower the guide rail.
3. Install the guide rail stop onto the guide rail and tighten at the 2" mark on the scale. Fig. 2
4. Using a pencil, mark a line along the full length of the mat board using the guide rail as a
guide. Fig. 3. Turn the mat 1/4 turn to the right before cutting.
5. Hook the bevel cutting head onto the guide rail and slide it up until the Start and Stop
indicator lines up with the marked line closest to the top of the machine.
6. With the left hand, depress the anti-crawl pin and pivot the blade holder to insert the blade
into the mat. Fig. 4
7. Release the anti-crawl pin and pull the bevel cutting head towards you until it gently contacts
the guide rail stop. Pivot the blade holder up to remove the blade from the mat.
8. Lift the guide rail and turn the mat 1/4 turn to the right.
9. Slide the bevel cutting head up to the cut just made in the mat and line up the start and stop
indicator for the next cut. Continue steps 6 through 9 to finish mat.
NOTE: In order for the production stops to be accurate, the blade depth must be set properly.
If using the stop produces an overcut or undercut, a blade depth adjustment may be needed.
(see page 8)
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
PLUS
M A T C U T T E R
Fig. 1
2"
Fig. 3
Fig. 4
M O D E L S 7 5 0 & 7 6 0
2"
Fig. 2
6