Table des Matières
Publicité
I N T E R M E D I A T E +
ORIENTATION
The procedure detailed in the following instructions refer to the right and left side,
and the top and bottom of the machine as shown. Fig. 1
A. Assembly
Mat Guide
To loosen, turn knobs counterclockwise and slide. Fig. 2
Slip Sheet
A Slip Sheet is a piece of scrap matboard placed underneath the mat to be cut
when bevel cutting. The Slip Sheet must be at least as long as the mat being cut
and at least 4" wide. This protects the blades while cutting and produces a better
cut. Fig. 3
NOTE: It is important not to continue to cut in the same spot of the Slip Sheet as
this can cause curves in the cut. Replace Slip Sheet as necessary.
B. Blade Installation
701 Straight Cutting Head
Remove the Blade Screw and the Blade Cover from the Blade Holder. Place one #270
blade, sharp edge down, in the slot on the Blade Holder and line up the hole in the
blade with the desired depth setting. Replace the Blade Cover and Blade Screw.
Fig. 4
The #701 has three depth settings:
Top setting - safety setting
Middle setting - standard thickness mat board (4-ply)
Bottom setting - 3/16" foamboard
NOTE: Always have the three holes on the Blade Cover lined up exactly with the
three holes on the Blade Holder before replacing the Blade Screw.
702 Bevel Cutting Head
NOTE: The following must be done before loosening blade screw.
Loosen the Retaining Screw found on the back side of the Cutting Head until flush
with the surface of the base. This allows the Blade Holder to tilt back all the way for
blade change. Slide one #270 blade all the way in the back of the Blade Holder as
shown. Fig. 5
NOTE: The hole in the blade is not designed to line up with the Blade Screw.
Re-Tighten the Blade Screw and tilt the Blade Holder down allowing the tip of the
blade to enter the Blade Slot. Retighten the Retaining Screw.
3
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Mat Cutter
For best results use only
authentic Logan blades
Fig 2
Mat Board
Fig 3
Slip Sheet
Fig 4
Fig 5
M O D E L 4 5 0
Top
Fig 1
Right
Left
Bottom
Publicité
Table des Matières
