Kenmore 78079 Mode D'emploi page 16

Installation
!
CAUTION
To avoid damage to outside wall of house, especially
if wall is weak or outside supports sit between studs
in wall, place wood blocks (not provided) between
wall and each adjusting foot.
8. See Figure 26. Place carpenters' level on outer
case. Rear of case should be ¼" to
front of case (about ¼ bubble on level). Turn each
adjusting foot on outside supports in or out until it
begins to contact wall. Adjust position to achieve
proper slope for case.
Figure 26. Adjusting Outer Case Slope
1. Level
2. Outer case
3. Wood block
1
2
3
!
CAUTION
To prevent damage to window locking or lifting
mechanisms from improperly placed sash bracket
screw, inspect window carefully before drilling or
installing screw in sash.
9. See Figure 27. Position sash bracket (Item F) on top
of indoor sash, flush with outdoor sash. Secure
bracket to outside sash using
screw (Item G). Drill a
easier to install.
3
/ " lower than
8
7
/ " sash bracket
8
1
/ " pilot hole so screw is
8
Figure 27. Installing Sash Bracket
1. Indoor sash
2. Sash bracket
3. Sash bracket screw
10. See Figure 28. Expand right side curtain on air
conditioner until curtain is tight against window
frame. With curtain tight against frame, find top hole
on curtain and mark location on indoor sash. Drill
1 / " pilot hole into window sash, and secure curtain
8
to sash with Phillips screw (Item H). Repeat for left
side curtain.
Figure 28. Securing Side Curtain
1. Indoor sash
2. Side curtain
1
2
11. See Figure 29. Measure and cut window seal strip
(Item I) to width of window. Stuff window seal strip
between outdoor glass and top of indoor sash for
tight seal to keep out heat and insects.
16
1
2
3